So, what do exhaust hangers actually do? Simply put, exhaust hangers hold the exhaust system in the correct position underneath your car. They might look like small, simple parts but they have quite a bit to deal with. The exhaust gets hot, expands as it heats up then contracts as it cools down. The engine also creates vibration, while bumps in the road make the whole system move around. Most exhaust hangers use rubber mounts to allow some movement without letting the pipes knock against the underside of the car.
Get that balance right and the system stays secure without being held completely rigid. Problems start when the rubber wears out or a metal bracket becomes damaged. The exhaust might begin sitting lower than normal, or you hear a clunk when driving over a rough patch of road. It can be easy to mistake this for something else, especially if the noise only happens occasionally.
Signs your exhaust hangers need attention
There are a few common signs worth looking out for:
- Rattling or knocking: The exhaust may hit the underside of the car over bumps or when the engine moves
- A sagging exhaust: The tailpipe might sit lower than usual or appear off-centre
- Visible damage: Rubber mounts can crack or stretch, while metal brackets may corrode or bend
Even one worn out exhaust hanger can put extra strain on the remaining mounts. The exhaust may still seem secure but other joints and supports are now dealing with more movement than they should. It is also worth checking the hangers when replacing an exhaust system. A new system fitted to worn mounts can end up with the same problems as the old one. Our guide to signs your exhaust mounts need replacing covers some of the warning signs in more detail.
Choosing the right replacement
Replacing a worn hanger is usually a straightforward job, provided the correct parts are used. The important thing is getting the right fit for the vehicle and exhaust system. A mount that is too short or too stiff can leave the exhaust sitting at the wrong angle or transfer more vibration than expected. We also offer Powerflex fitting kits for specific applications.
These use polyurethane bushes, which are generally firmer than standard rubber. They can help limit unwanted movement, although the change in stiffness may also affect the amount of vibration or noise felt in the car. Before fitting anything, check the condition of the surrounding brackets, hangers and joints. There is little point replacing one worn component only to find another is damaged a few inches away. Never get underneath a vehicle supported only by a jack. Proper support is essential, even for what looks like a quick job.

